Dual Latching Relay
Latching Relay Momentary-to-Toggle (Bi-Stable) Switching
The Toggle module is an auxiliary device
designed to allow easy and reliable arming/disarming momentary, two
wire start stop circuit, or with
hand-held wireless remote controls. It may be looked upon as an
easy-to-use, cost-effective "momentary-to-toggle (bi-stable)"
|Momentary closure of the terminals A1 and
S will latch the
A subsequent momentary closure of the contacts will unlatch the
Reset the Toggle relay by removing power from
terminal A1 or A2
The relay provides
N.O. and N.C. contacts, and can therefore be used with a wide
variety of control applications.
- Replaces the normal ON/OFF with an electronic
- The relay provides N.O. and N.C. outputs.
- Operating power - 12, 24VDC or
24, 110, 220VAC
- Current drain - less than 1mA (unlatched), 30 mA
- Relays switching capability –
15A / 250VAC.
- DIN mount
Latch -Toggle circuits in one unit
closure of terminal S1 will latch the relay. Q1
A subsequent momentary closure S1 will unlatch
the relay Q1 OFF
Momentary closure of terminal S2 will latch the
relay. Q2 ON
A subsequent momentary closure S2 will unlatch
the relay Q2 OFF
Momentary closure of terminal I4 will reset both
Auto reset on power loss
Drive contactors, relays
for lighting control, remote control,
automation, two wire pulse control ON/OFF
- The LATCH
relay provides N.O. outputs.
power selection: 12 /24 VDC or 120/240 VAC
drain - less than 10mA (unlatched), 60 mA
switching capability – 10A / 250VAC.
- 2 x 2.5 x 3.5 inches
( 48 x 64 x 90 mm)
DIN rail mount
Reset All (included)